User manual

2
2-196
E/OS Command Line Interface User Manual
show
Output The features data is displayed as a table that includes the following
properties.
Output Example The output from the show.fabric.topology command appears as follows:
Switch WWN DID OutPrt Remote WWN RemDID RemPrt
------------------------ --- ------ ----------------------- ------ ------
02:30:40:32:34:34:32:21* 2 24 24:45:73:49:05:43:22:11 10 2
25 24:45:73:49:05:43:22:11 10 3
26 24:45:73:49:05:43:22:11 10 4
24:45:73:49:05:43:22:11 10 2 02:30:40:32:34:34:32:21 2 24
3 02:30:40:32:34:34:32:21 2 25
4 02:30:40:32:34:34:32:21 2 26
21:23:21:25:76:43:23:21 10 7 02:30:40:32:34:34:32:21 15 3
02:30:40:32:34:34:32:21 15 3 21:23:21:25:76:43:23:21 10 7
show.fabric.traceRoute
Syntax traceRoute source destination
Description This command retrieves the route between two nodes in the fabric.
Parameters This command has two parameters:
Command Example
Root> show fabric traceRoute
Switch WWN The WWN of the switch at the local end of the ISL.
DID The Domain ID of the switch at the local end of the
ISL.
OutPrt The port number at the local end of the ISL.
Remote WWN The WWN of the switch at the remote end of the ISL.
RemDID The domain ID of the switch at the remote end of the
ISL.
RemPrt The port number at the remote end of the ISL.
source The source port for the trace route. This can be
either a Port ID or a WWN.
destination The destination port for the trace route. This can be
either a Port ID or a WWN.