User manual

2
2-194
E/OS Command Line Interface User Manual
show
Output Example Principal Switch WWN: 00:00:00:00:00:00:00:00
show.fabric.showRouteTable
Syntax showRouteTable [source] [destination]
Description This command displays routes for specified online ingress port to
specified domains in the fabric.
Parameters This command has two parameters, which are optional.
NOTE: If a parameter is not mentioned, then all the online ports and
domains will be displayed.
Command Example Root> show fabric showRouteTable
Output The data is displayed as a table that includes the following
properties:
source The source port/Ingress port for which the route
table is displayed.
destination The destination Domain ID for which the route is
displayed.
Ingress The ingress port on the switch.
DID The destination Domain ID.
Egress The egress port on the switch.
Rem DID The neighboring switch's Domain ID.
Rem Ingress The ingress port on the neighboring switch.
Hops The number of hops the route makes to reach the
neighboring DID.
Act Cost* True cost of the link based on the port speed.
Eff Cost* This is the FSPF cost of routing.
Path Specifies if the path is a Preferred Path. Valid values
are Ye s or No.