User manual

2
CLI Commands
2-187
show
Parameters This command has five parameters:
Command Example
show.EPFrameLog> setTrigger 5 0 FFXXXXX3452 0 FBXXXXX3321
NOTE: Once the trigger conditions have been met, user will have to clear the
filter manually. No new entries are written to the frame log until the user
initiates it.
show.epFrameLog.wrap
Syntax wrap [clear]
Purpose This command displays the contents of the wrapping region of the
FC2 frame log. Specifying the optional keyword clear clears all entries
from both the wrapping and the non-wrapping regions of the log.
The log entries will not persist over IMLs or power cycles, and will
not be stored in NV RAM. This log will not include entries for frames
portNumber The port to monitor this trigger on. Valid values
are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
offStart The offset for the start bit pattern.
bitStart The bit pattern that will trigger the logging. 'X' or 'x'
can be used as a wild card.
offEnd The offset for the end bit pattern.
bitEnd The bit pattern that will end the logging. 'X' or 'x'
can be used as a wild card.