User manual

2
2-182
E/OS Command Line Interface User Manual
show
---------- ----------- ------- -------------
11/24/03 04:18P Switch set online CLI 172.16.22.23
11/24/03 03:38P Switch name modifiedCLI 172.16.22.23
11/24/03 03:38P Switch set offline CLI 172.16.22.23
11/24/03 11:27A Firmware downloaded Web 172.60.5.40
show.epFrameLog.config
Syntax config
Purpose This command shows the current embedded port frame log settings.
Parameters This command has no parameters.
Command Example
Root> show epFrameLog config
Output The output from this command contains the following data:
Command Example
Root> show EPFrameLog config
Filter Class F Frames: Disabled
Filter Port: 15
Start Offset: 0
Start Bit Pattern: FFXXXXX3452
Filter Class F Frames If enabled, then filtering of Class F frames will take
place.
Filter Port The port that is being filtered on.
Trigger State The state of the trigger. Active if the trigger
conditions have not been met.
Num of Entries Number of frames that have been logged since the
start condition was met.
Start offset The number of bytes into the frame to where the
start bit pattern will be looked for.
Start Bit Pattern The bit pattern that triggers the logging to begin.
End Offset The number of bytes into the frame to where the
end bit pattern will be looked for.
End Bit Pattern The bit pattern that triggers the logging to end.
Start Condition Met True if the start condition was met.
End Condition Met False if the end condition was not met.