User manual

2
2-176
E/OS Command Line Interface User Manual
perf
Parameters This command has one parameter:
NOTE: The output of this command truncates all the threshold alert names
that are longer than 51 characters. In case you specify lengthy names, you can
display the complete name by entering the comma-delimited mode using the
commaDelim command. For more information, see Using the commaDelim
Command on page 1-19.
Command Example Root> perf thresholdAlerts throughput show eportRx
Output Example The output from the perf.thresholdAlerts.throughput.show command
appears as follows:
Name: 90% Receive Throughput Threshold
Ports: 5,8,12,20-24
Utilization Type: Rx
Utilization Percentage: 90%
Duration: 15
Interval: 30
Alert State: Disabled
perf.thresholdAlerts.throughput.showUtilTypeTable
Syntax showUtilTypeTable
Purpose This command displays a table of the utilization types that can be
used for a throughput threshold alert. This table is used for reference
only.
Parameters This command has no parameters.
Command Example
Root> perf thresholdAlerts throughput showUtilTypeTable
Output Example The output from the perf.thresholdAlerts.throughput.showUtilTypeTable
command appears as follows:
NumberUtilization Type
----------------------------
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-170.
You can also specify all instead of a name, to
display all threshold alerts.