User manual

2
CLI Commands
2-175
perf
perf.thresholdAlerts.throughput.setParams
Syntax setParams name duration interval
Purpose This command sets the name, duration, and interval for a specified
throughput threshold alert. It also enables you to configure an alert to
be sent when the following two events occur at the same time.
• The throughput threshold alert value is surpassed to more than
the timespan specified in the duration parameter.
• The duration parameter is surpassed within the time frame
specified by the interval parameter.
Parameters This command has the following parameters:
Command Example
Root> perf thresholdAlerts throughput SetParams eportRx 1
10
perf.thresholdAlerts.throughput.show
Syntax show name
Purpose This command displays the settings for an individual throughput
threshold alert.
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert,
described on 2-170.
duration The duration time in minutes that the utilization
must exist to trigger the alert. Acceptable values
are in the range 0 to 70,560 minutes. Setting this
value to zero means that the alert is triggered if
the specified utilization is exceeded at any time.
The value of this parameter must be less than or
equal to the value of the interval parameter.
interval This sets the interval time in minutes. The
interval is a fixed length of time. It is not a
rolling window of time. Acceptable values are in
the range 5 to 70,560 minutes. The value of this
parameter must be greater than or equal to the
value of the duration parameter.