User manual

2
2-174
E/OS Command Line Interface User Manual
perf
Parameters This command has the following parameters:
Command Example
Root> perf thresholdAlerts throughput setUtilType
eportRx 1
perf.thresholdAlerts.throughput.setUtilPercentage
Syntax setUtilPercentage name utilizationPercentage
Purpose This command sets the throughput utilization percentage that is used
to trigger the throughput threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters:
Command Example
Root> perf thresholdAlerts throughput setUtilPercentage
eportRx 70
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert, described on
2-170.
utilizationType The type of traffic that triggers the alert. Enter the
number that corresponds to the desired utilization
type:
1 - Transmit Traffic (Tx)
2 - Receive Traffic (Rx)
3 - Both (Rx and Tx)
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert, described
on 2-170.
utilizationPercentage The percentage of throughput utilization that
triggers the alert. This must be entered as a
number. Accepted values are in the range 1 to
100.