User manual

2
CLI Commands
2-171
perf
• Alert State: Disabled
Parameters This command has one parameter:
TIP: Although the system supports a name length of 64 characters, you may want to
use a much shorter name. Some commands that display the threshold name show a
maximum of 51 characters. If you specify lengthy names, you can display the complete
name by entering the comma-delimited mode using the commaDelim command. For
more information, see Using the commaDelim Command on page 1-19.
Command Example Root> perf thresholdAlerts throughput addAlert port6Rx
perf.thresholdAlerts.throughput.addPort
Syntax addPort name portNumber
Purpose This command adds a port to the specified throughput threshold
alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters:
name Specifies the name of the new throughput threshold
alert. This name can consist of any ASCII characters
up to a maximum length of 64 characters. To use
spaces or special characters in this name, put
quotation marks around the name. This parameter
is case-sensitive.
name The name of a throughput threshold alert as
defined by the command
perf.thresholdAlerts.throughput.addAlert, described on
2-170.