User manual

2
CLI Commands
2-165
perf
Parameters This command has the following parameters:
Command Example
Root> perf thresholdAlerts counter setCounter checklinks 1
perf.thresholdAlerts.counter.setParams
Syntax setParams name increment interval
Purpose This command sets the increment and interval times for a specified
counter threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
Parameters This command has the following parameters:
Example If ports 0,1, or 2 CRC Error counter increments more then 5 times
within a period of 30 minutes, send an alert.
Port list = 0, 1, 2
CTA Counter = CRCErrors
Increment value= 5
Interval Time = 30
name The name of a counter threshold alert as defined by
the command perf.thresholdAlerts.counter.addAlert,
described in 2-161.
counterNumber Specifies the counter number. Valid values are
shown in Table 2-3, Alert Counters, page 2-159.
name The name of a counter threshold alert as defined by
the command perf.thresholdAlerts.counter.addAlert,
described on 2-161.
increment This sets the number of times a counter must
increment during the interval period to trigger the
alert. Acceptable values are in the range of 1 to
70,560.
interval This sets the interval time in minutes for the alert.
Acceptable values are in the range of 5 to 70,560
minutes.