User manual

2
CLI Commands
2-157
perf
perf.preferredPath.showState
Syntax showState
Purpose This command shows the enabled state for preferred path
Parameters This command has no parameters.
Command Example
Root> Perf PreferredPath showState
perf.thresholdAlerts
The perf.thresholdAlerts commands enable you to configure alerts that
notify you of specific conditions on your system.
You can configure a maximum of 16 threshold alerts, including both
counter threshold alerts (CTAs) and throughput threshold alerts
(TTAs). Each of these types of alerts have commands that are specific
to the alert type.
• Counter threshold alerts: These are alerts that are triggered by
counts of events. The commands used to configure these alerts
start with perf.thresholdAlerts.counter.
• Throughput threshold alerts: These alerts are triggered by port
throughput. The commands used to configure these alerts start
with perf.thresholdAlerts.throughput.
For a list of the available threshold alerts counters, see Alert Types and
Counters on page 2-159.
Creating Threshold Alerts
The tasks you need to complete to create and activate a threshold
alert differ depending on the type of alert you are creating. To
implement a counter threshold alert, see Activating a Counter
Threshold Alert below. To implement a throughput alert, see
Activating a Throughput Threshold Alert on page 2-158.
Activating a Counter Threshold Alert
In order to activate a counter threshold alert using the CLI, you must
enter certain commands in the order specified in this section.