User manual

2
CLI Commands
2-155
perf
perf.preferredPath.showPath
Syntax showPath destDomainID sourcePort
Purpose This command displays the requested preferred path configuration.
The output shows the configured preferred exit port. Using all for
either the destination domain ID or the specified source port
parameter results in an output that shows all configured and actual
exit ports for the other parameter. If the destination domain is set to
all, then all paths from the specified source port are displayed. If the
source port is set to all, the output shows all source port paths to the
specified domain. You cannot specify all for both the parameters.
Parameters This command has the following parameters:
destDomainId Specifies the destination domain ID. Valid domain
IDs are in the range 1–31 or all, which shows all paths
to and from the source port specified in the
sourcePort parameter.
sourcePort Specifies the number of the source port. Valid port
numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or, you can specify all to show all paths to the
destination domain ID specified for the
destDomainId parameter.