User manual

2
CLI Commands
2-153
perf
perf.preferredPath.setPath
Syntax setPath destDomainID sourcePort exitPort
Purpose This command sets a preferred exit port, given the destination
domain ID and source port. An exit port can be set for each
combination of destination domain ID and source port.
NOTE: You cannot set a path where the Destination Domain ID is the same
as the domain ID of the switch.
Parameters This command has the following parameters:
destDomainId Specifies the destination domain ID. Valid domain
IDs are in the range 1–31.
sourcePort Specifies the number of the source port. Valid port
number values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–15 for the Sphereon 4400
0–23 for the Sphereon 45000–31 for the Sphereon 3032
and 3232
0–31 for the ED-5000
0–31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140