User manual

2
2-146
E/OS Command Line Interface User Manual
perf
Output Example The output from the perf.link command appears as follows:
Port 2
Statistic Count
----------- ----------
OLS In 753452
OLS Out 351269
Reset In 2953184
Reset Out 1842953
Link Flrs 2953184
Sync Losses 1842953
Sig Losses 35246
Time at 0 Tx Credit 0
perf.openTrunking.backPressure
Syntax backPressure backPressureState
Purpose This command configures the Back Pressure state of the
OpenTrunking configuration.
Parameters This command has one parameter:
Command Example
Root> perf openTrunking backPressure 1
Sync Losses The number of times the port has detected a loss of
synchronization timeout while not in an offline or
LF2 state.
Sig Losses The number of times the port has detected a loss of
signal while not in an offline or LF2 state.
Time at 0 Tx Credit The number of 100 millisecond intervals where the
switch port has zero Tx BB_Credit.
backPressureState This parameter can be set to enable or disable
OpenTrunking back pressure. Boolean 1 and 0
values may also be substituted. If the state is
configured to be enabled, a back pressure entry is
made to the Event Log and an SNMP trap is
generated if SNMP is configured.