User manual

2
CLI Commands
2-131
config
Purpose This command changes the name of the zone set in the work area.
NOTE: Changes are not activated on the switch until the
config.zoning.activateZoneSet command is issued.
Parameters This command has one parameter:
Command Example
Root> config zoning renameZoneSet TheUltimateZoneSet
config.zoning.replaceZoneSet
Syntax replaceZoneSet
Purpose This command replaces the work area with the active zone set that is
currently loaded on the fabric.
Parameters This command has no parameters.
Command Example
Root> config zoning replaceZoneSet
config.zoning.setDefZoneState
Syntax setDefZoneState defaultZoneState
Purpose This command enables or disables the default zone and takes effect
immediately fabric wide.
NOTE: This command takes effect immediately in the fabric.
zoneSetName Specifies the new name for the zone set. The
zoneSetName must contain 1–64 characters. Valid
characters are:
ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghijkl
mnopqrstuvwxyz0123456789$-^_
Spaces are not permitted, and the first character must
be alphabetical.