User manual

2
2-124
E/OS Command Line Interface User Manual
config
NOTE: A Sphereon 4300 Switch cannot participate in a fabric unless the
Fabric Capable feature is enabled. For more information, see the McDATA
Sphereon 4300 Switch Installation and Service Manual (620-000171).
Table 2-1 shows the limits for configuring zoning in McDATA fabrics
that are supported by switch and director firmware as of 11/14/03.
Although EFCM 8.0 or EFCM 8.0b may allow you to configure
greater values in the Zoning Library, values in this table have been
tested and are supported. For the latest limits, refer to the Supported
Fabrics Configuration Document located on www.mcdata.com in the
Resource Library or contact your customer support representative.
config.zoning.activateZoneSet
Syntax activateZoneSet
Purpose This command activates the zone set contained in the work area to
the fabric and takes effect immediately.
NOTE: This command takes effect immediately in the fabric.
Parameters This command has no parameters.
Command Example
Root> config zoning activateZoneSet
Table 2-1 Supported Zoning Configurations
Product
Intrepid 6064
Intrepid 6140
Sphereon
4700
Sphereon
4400
Sphereon
4500
Sphereon
4300
Sphereon
3x32
Sphereon
3x16
ED-5000
Number of End
Ports
1024 1024 1024 1024 1024 1024 1024
Unique Zone
Members
4096 4096 4096 4096 4096 4096 1042
Members per Zone 4096 4096 4096 4096 4096 4096 1024
Zones 2048 2048 2048 2048 2048 2048 512