User manual

2
2-120
E/OS Command Line Interface User Manual
config
Output The syslog configuration is shown as a table of properties. The
following properties are displayed:
Command Example
Root>Config SysLog show
Syslog State: Disabled
Index IP Address Facility
----- --------------- --------
1 172.16.22.23 Local 0
2
3 180.77.66.55 Local 5
Log State
-------------------------- --------
Event Log Enabled
Open Trunking Re-Route Log Disabled
Link Incident Log Disabled
Security Log Enabled
Audit Log Enabled
Fabric Log Enabled
Embedded Port Frame Log Disabled
config.system
With the system command, the configuration branch enters the
system configuration branch. All commands under this branch
operate on a particular system attribute. System attributes are generic
attributes that are not specific to Fibre Channel, and thus would be
present on any product.
config.system.contact
Syntax contact systemContact
Purpose This command sets the system contact attribute.
Log The index number of the server.
State Reports if syslog support is enabled.
Index The index number of the server.
IP Address The IP address of the server.
Facility The facility level for the server. Values are Local 0 -
Local 7.