User manual

2
CLI Commands
2-119
config
Purpose This command enables syslog support for the given log.
Parameters This command has two parameters:
Command Example
Root> config syslog setLogConfig event enable
config.syslog.setState
Syntax setState enabledState
Purpose This command sets the enabled or disabled state for the syslog
feature.
Parameters This command has one parameter:
Command Example
Root> config syslog setState enable
config.syslog.show
Syntax show
Purpose This command displays the syslog configuration.
NOTE: The command show.syslog on page 2-251 has functionality that is the
same as this command.
Parameters This command has no parameters.
logName The log type. Possible values are Event, Trunking,
Link, Security, Audit, Fabric, and Frame.
state This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be substituted. If
the state is enabled, messages for that log will be
sent to the configured syslog servers.
enabledState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be substituted.