User manual

2
CLI Commands
2-115
config
Parameters This command has no parameters.
Command Example
Root> config switch show
Output The switch configuration data is displayed as a table that includes the
following properties:
R_A_TOV Resource Allocation Time Out Value. This time outs
the operations that depend on the maximum possible
time that a frame can be delayed in a fabric and still
be delivered.
E_D_TOV Error Detect Time Out Value. This indicates the
maximum turnaround time that an operation could
require.
Preferred Domain ID The preferred domain ID of the switch.
Switch Priority The switch priority. Values are Principal is 1, Default
is 2 to 254, or Never Principal is 255.
Speed The switch speed. (This is available only for intrepid
6064)
Rerouting Delay The rerouting delay that ensures that frames are
delivered in order through the fabric to their
destination. Values are Enabled or Disabled.
Interop Mode Interoperability mode for the switch.
Insistent Domain Id When enabled, this ensures that the embedded
firmware cannot change the preferred domain ID of a
switch.
Domain RSCN When enabled, this allows domain RSCNs to be sent
to registered members of the fabric.
Zoning RSCN When enabled, allows zoning RSCNs to be sent to
registered members of the fabric.
Limited Fabric RSCN When enabled, fabric RSCNs are suppressed after an
IPL.
Zone FlexPars When set to fabric, RSCNs will only be sent to
affected fabric members when zoning information
changes. When set to none, filtering of RSCNs will not
take place, and RSCNs will be sent to all zoneset
members when zoning information changes.