User manual

2
CLI Commands
2-113
config
If rerouting delay is enabled, traffic ceases in the fabric for the time
specified in the config.switch.edTOV command. This delay allows
frames sent on the old path to exit to their destination before new
frames begin traversing the new path. Note that during this delay
period, frames addressed to the destinations that are being rerouted
are discarded if they are Class 3 frames and rejected if they are Class
2 or Class F frames.
Parameter This command has one parameter:
Command Example
Root> config switch rerouteDelay true
config.switch.RSCNZoneIsolation
Syntax RSCNZoneIsolation RSCNZoneIsolationState
Description This command configures the state of RSCN Zone Isolation.
Parameters This command has one parameter:
config.switch.safeZoning
Syntax safeZoning safeZoningState
Purpose This command sets the state for safe zoning. When enabled, zone
merges will not happen unless zone sets are equivalent; in addition,
the option to set the default zone will be disabled.
rerouteDelayState Specifies whether rerouting delay is enabled. Valid
values are true and false. Boolean 1 and 0 may be
substituted as values.
RSCNZoneIsolationState This parameter can be set to fabric and
none.
When set to fabric, RSCNs will only be
sent to affected fabric members when
zoning information changes.
When set to none, filtering of RSCNs will
not take place, and RSCNs will be sent to
all zoneset members when zoning
information changes.