User manual

2
CLI Commands
2-111
config
Parameters This command has one parameter:
Command Example
Root> config switch prefDomainId 1
config.switch.priority
Syntax priority Priority
Purpose This command sets the switch priority.
NOTE: The switch must be set offline before this command is entered.
Parameters This command has one parameter:
Command Example
Root> config switch priority principal
domainId Specifies the new preferred domain ID value. This
parameter must be an integer in the range 1–31.
Priority Specifies the switch priority. Valid values are:
principal, default, or neverprincipal.
principal — sets the numerical switch priority to 1.
The switch with a priority of 1 becomes the principal
switch; however, if two or more switches have a
priority of 1, the switch with the lowest WWN
becomes the principal switch.
default — sets the numerical switch priority to 254. If
no switch is set to principal, the switch with a
priority 254 becomes the principal switch; however,
if two or more switches have a priority of 254, the
switch with the lowest WWN becomes the principal
switch.
neverprincipal — sets the numerical switch priority to
255. This disables the switch from becoming a
principal switch.
At least one switch in a multiswitch fabric must have
a switch priority value of principal or default.
The number codes 2–253 are not in use now.