User manual

2
2-110
E/OS Command Line Interface User Manual
config
shortest path (or the path which would take the least amount of time
for traffic to travel) to a destination.
Parameters This command has two parameters:
TIP: It is recommended that all the switches in the fabric to be configured have the
same value for the ISL FSPF Cost Configuration parameter.
Command Example Root> config switch islFSPFCost ignore
config.switch.ltdFabRSCN
Syntax ltdFabRSCN ltdFabRSCNState
Purpose This command sets the status of limited fabric RSCNs. When enabled,
fabric registered state change notifications (RSCNs) are suppressed
during an IPL.
Parameters This command has one parameter:
Command Example
Root> config switch ltdFabRSCN 1
config.switch.prefDomainId
Syntax prefDomainId domainId
Purpose This command sets the preferred domain ID for the switch or
director. The switch or director must be offline to complete this
command.
ignore
Every ISL has the same FSPF cost. In essence,
the actual FSPF cost is ignored.
port
Each ISL has a McDATA default cost, which
depends on the speed of the port.
ltdFabRSCNState Specifies whether the limited fabric RSCN state is
enabled. Valid values are enable and disable. Boolean 1
and 0 may be substituted as values.