User manual

2
CLI Commands
2-109
config
Parameters This command has one parameter:
Command Example
Root> config switch insistDomainId 1
NOTE: The Insistent Domain ID must be enabled if the Enterprise Fabric
Mode (an optional SANtegrity feature) or Preferred Path is enabled.
config.switch.interopMode
Syntax interopMode interopMode
Purpose This command sets the interoperability mode for the switch. The
switch must be offline to complete this command.
NOTE: The switch must be set offline before this command is entered.
Parameters This command has one parameter:
Command Example
Root> config switch interopMode open
config.switch.islFSPFCost
Syntax islFSPFCost islFSPFCostState
Purpose This command configures the Fabric Shortest Path First (FSPF) cost of
Inter-Switch Links (ISLs) on the switch. Cost is used to determine the
insistentDomainIdState Specifies whether the insistent domain ID state
is enabled. Valid values are enable and disable.
Boolean 1 and 0 may be substituted as values.
interopMode Specifies the interoperability mode. Valid values are
mcdata and open:
mcdata — McDATA Fabric 1.0. Select this mode if the
fabric contains only McDATA switches and directors
that are also operating in McDATA Fabric 1.0 mode.
open — Open Fabric 1.0. Select this mode if the fabric
contains McDATA switches and directors and other
Open Fabric-compliant switches. Select this mode for
managing heterogeneous fabrics.