User manual

2
2-108
E/OS Command Line Interface User Manual
config
config.switch.edTOV
Syntax edTOV timeoutValue
Purpose Sets the error detect timeout value (E_D_TOV) for the switch.
NOTE: The switch must be set offline before this command is entered.
Special care should be used when scripting this command due to its
relationship with R_A_TOV.
Parameters This command has one parameter:
Command Example
Root> config switch edTOV 4
config.switch.haMode
Syntax haMode haEnabledState
Purpose This command sets the state of high availability.
Parameters This command has one parameter:
Command Example
Root> config switch haMode enable
NOTE: This command is applicable only to Sphereon 4400.
config.switch.insistDomainId
Syntax insistDomainId insistentDomainIdState
Purpose This command sets the insistent domain ID state for the switch.
timeoutValue Specifies the new E_D_TOV value. The units for this
value are tenths of a second. This parameter must be
an integer in the range 2–600 (0.2 second to 60
seconds), and it must be smaller than the R_A_TOV.
haEnabledState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be substituted.