User manual

2
CLI Commands
2-107
config
Parameters This command has one parameter:
Command Example
Root> config switch domainIDOffset 160
config.switch.domainRSCN
Syntax domainRSCN domainRSCNState
Purpose Sets the domain RSCN state for the switch or director. You can run
this command when the switch or director is either offline or online.
When this parameter is enabled, domain registered state change
notifications (domain RSCNs) are sent between end devices in a
fabric to provide additional connection information to host bus
adapters (HBA) and storage devices.
As an example, this information might be that a logical path has been
broken because of a physical event, such as a fiber optic cable being
disconnected from a port.
Parameters This command has one parameter:
Command Example
Root> config switch domainRSCN 1
offset The Domain ID offset. Values are in hexadecimal.
Valid values are:
00
32
64
96
128
160
192
domainRSCNState Specifies whether the domain RSCN state is
enabled. Valid values are enable and disable. Boolean
1 and 0 may be substituted as values.