User manual

2
CLI Commands
2-101
config
config.snmp.showV3GroupTable
Syntax showV3GroupTable
Purpose This command displays the Security-to-Group table.
Parameters This command has no parameters.
Output This command displays the following switch configuration data:
Example
config.SNMP> showV3GroupTable
SNMPv3 State: Enabled
Index Username Model Group Name
----- -------------------------------- ----- ----------
1 User1 V1 Group1
2
3
4
5
6
NOTE: This command and the command show.snmp.V3GroupTable on
page 22-244 has the same functionality.
config.snmp.showViewTable
Syntax showViewTable
Purpose This command displays the values for the VACM views presently
configured.
Parameters This command has no parameters.
SNMPv3 State Indicates whether SNMPv3 is enabled or disabled.
Index The index number.
Username The username.
Model The security model.
Group Name The group name.