User manual

2
2-100
E/OS Command Line Interface User Manual
config
NOTE: The command show.snmp.targetTable on page 22-242 has functionality
that is same as that of this command.
config.snmp.showUserTable
Syntax showUserTable [index]
Purpose This command displays the users configured presently in the USM
table.
Parameters This command has no parameters.
Output This command displays the following switch configuration data:
Command Example
Config.SNMP> showUserTable
SNMPv3 State: Enabled
Index Username Auth Protocol Privacy Protocol
----- -------------------------------- ----------------- ----------------
1 User1 No Authentication No Privacy
2 User2 HMAC-MD5 No Privacy
3 User3 HMAC-SHA DES
4
5
6
NOTE: This command and the command show.snmp.userTable on page 22-243
has the same functionality.
Security Name The security name (user name).
Security Model The security model.
Security Level The security level.
SNMPv3 State Indicates whether SNMPv3 is enabled.
Index The index number.
Username The user name.
Auth Protocol The authentication protocol.
Privacy Protocol The privacy protocol.