User manual

2
CLI Commands
2-99
config
Parameters This command has one optional parameter:
Command Example
Config.SNMP> showTargetTable
SNMPv3 State: Enabled
Index Target IP UDP Port Community MP Model
----- ------------- -------- -------------------------------- --------
1 172.19.16.169 162 public SNMPv1
2
3
4
5
6
or
Specifying the index will give the following output:
Config.SNMP> showTargetTable 1
Index: 1
Target IP: 172.19.16.169
UDP Port: 162
Community Name: public
MP Model: SNMPv1
Security Name: user1
Security Model: V1
Security Level: No Authentication and No Privacy
These are explained in the table below.
index Index of the access entry. Valid values are 1 to 6.
SNMPv3 State Indicates whether SNMPv3 is enabled.
Index The index number.
Target IP The IP address of the trap recipient.
UDP Port The UDP port of the trap recipient.
Community The community name.
MP Model The messaging model.