User manual

2
CLI Commands
2-97
config
Output Example The output from the config.snmp.show command appears as follows:
SNMP Agent State: Enabled
FA MIB Version Number: 3.0
Authentication Traps: Enabled
Index Community Name WriteAuth Trap Recipient UDP Port
----- ----------------------------- --------- --------------- ------
1 CommunityName1 Enabled 123.123.123.123 162
2 CommunityName2 Enabled 10.25.25.10 144
3 CommunityName3 Disabled 132.44.85.224 162
4 public Enabled 162
5
6
config.snmp.showAccessTable
Syntax showAccessTable [index]
Purpose This command displays the configured values for the access table.
Parameters This command has one optional parameter:
Command Example
Config.SNMP> showAccessTable
SNMPv3 State: Enabled
Index Group Name
FA MIB Version
Number
Version of the Fibre Alliance MIB (FA MIB) that the
SNMP agent is configured to use.
Authentication
Traps
The state of the authentication traps (for example,
enabled) that are sent to SNMP management stations
when unauthorized stations attempt to access SNMP
information from the switch.
Index The community index number.
Community Name The name of the community.
WriteAuth The write authorization state.
Trap Recipient The address of the trap recipient shown in 4-byte
dotted-decimal format.
UDP Port The User Datagram Protocol (UDP) port number to
which the switch will send traps for each recipient.
index Index of the access entry. Valid values are 1 to 12.