User manual

2
2-96
E/OS Command Line Interface User Manual
config
Purpose This command sets the version of the Fibre Alliance MIB with which
the SNMP agent interacts. The version number can be set to 3.0 or 3.1.
Parameters This command has one parameter:
Command Example
Root> config snmp setFaMibVersion 3.1
config.snmp.setState
Syntax setState enabledState
Purpose This command enables or disables the SNMP agent. When disabled,
the SNMP agent does not respond to any requests or send any traps.
Parameters This command has one parameter:
Command Example
Root> config snmp setState 1
config.snmp.show
Syntax show
Purpose This command shows the SNMP configuration of the switch.
Parameters This command has no parameters.
Command Example
Root> config snmp show
Output The switch configuration data is displayed as a table that includes the
following properties:
versionNumber Sets the version of the Fibre Alliance MIB version
number. Accepted values for this command are 3.0 or
3.1.
enabledState Sets the state of the SNMP agent. This parameter
can be set to enable or disable. Boolean 1 and 0 values
may also be substituted.
SNMP Agent State The state of the SNMP agent. If it is disabled, the
SNMP agent does not respond to any requests and
does not produce any traps.