User manual

2
CLI Commands
2-93
config
Command Example Root> config snmp addv3target 6 124.56.67.98 165
Root> config snmp addv3target 6 124.56.67.98
config.snmp.authTraps
Syntax authTraps enabledState
Purpose This command enables or disables the authentication traps to be sent
to the SNMP management stations when unauthorized stations try to
access SNMP information from the director or switch.
Parameters This command has one parameter:
Command Examples
Root> config snmp authTraps enable
Root> config snmp authTraps 1
config.snmp.deleteAccessEntry
Syntax deleteAccessEntry index
Purpose This command deletes the specified entry from the access table.
Parameters This command has 1 parameter:
Command Example
Root> config snmp deleteAccessEntry 1
config.snmp.deleteCommunity
Syntax deleteCommunity commIndex
Purpose This command deletes an SNMP community and trap recipient, if
configured.
enabledState Specifies whether the authentication traps are
enabled. Valid values are enable and disable. Boolean 1
and 0 may be substituted as values.
commIndex Index of the access entry. Valid values are 1 to 6.