User manual

2
2-76
E/OS Command Line Interface User Manual
config
Parameters This command has no parameters.
Command Example
Root> config security switchACL show
Output This command displays the following access control list information:
Output Example The output from the config.security.switchAcl.show command appears
as follows.
ACL State: Disabled
Starting IP Address Ending IP Address
------------------- -----------------
110.80.1.1 110.80.255.255
110.81.1.10 110.81.1.255
200.11.15.1 200.11.255.128
config.security.switchBinding
Switch Binding CLI commands allows users to enable the switch or
director to communicate only with nodes, switches, and directors
that are listed on the Switch Binding Membership List (SBML).
Switch Binding is available only if the SANtegrity Binding feature is
installed.
When an unauthorized WWN attempts to log in, it is denied a
connection and an event is posted to the Event Log. This provides
security in environments that include a large number of nodes,
switches, and directors by ensuring that only the specified set of
WWNs are able to attach to the managed product.
Enable, Disable and
Online State Functions
For Switch Binding to function, specific operating parameters and
optional features must be enabled. Also, there are specific
requirements for disabling these parameters and features.
• Switch Binding can be enabled or disabled whether the switch or
director is offline or online.
• Enabling Enterprise Fabric Mode automatically enables Switch
Binding.
Starting IP Address The starting IP Address of the range in the access
control list.
Ending IP Address The ending IP Address of the range in the access
control list.