Specifications

74 Getting Started with the McDATA Intrepid FICON Director
Figure A-4 HyperTerminal session
Altering an IP address in a CTP card
There are no restrictions for the IP address range used for the McDATA Intrepid. To change
an IP address, the following steps must be performed:
1. If the HyperTerminal window is displayed, press Enter and type in the password as
described under “Setting up a HyperTerminal session” on page 72.
2. Type in the command
ipconfig to display the current settings.
3. If changes are necessary, type in
ipconfig ,and then separated by a blank, type in the
new IP address.
If more than one parameter has to be changed, you can enter the values in one string, but
each field has to be separated by a blank.
4. Entering the command
ipconfig again displays the new value to verify the setting is
correct.
5. To terminate the session, type
exit.
>xxxxxxxx
C>ipconfig
MAC Address: 08 00 88 A0 DC DA
IP Address: 10.1.8.8
Subnet Mask: 255.255.0.0
Gateway Address: 0.0.0.0
C>help ipconfig
[] = optional | = or ^ = optional space
() = required + = and/or ... = repetition
IPCONFIG Configure IP parameters: [ <ipAddress> [ <ipMask> [ <ipGateway> ] ] ]
C>ipconfig 10.1.8.2 255.0.0.0 0.0.0.0
Request Completed: OK
C>ipconfig
MAC Address: 08 00 88 A0 DC DA
IP Address: 10.1.8.2
Subnet Mask: 255.0.0.0
Gateway Address: 0.0.0.0
C>exit
>
IP address
Mask
Gateway