Specifications

Appendix A. Useful procedures 73
3. Select COM1 and click OK. Ensure the null modem cable is connected to this port. The
Port Settings window is displayed.
Figure A-3 COM1 properties panel
4. On the COM1 properties screen set the following parameters:
– Bits per second: 57600
– Data Bits: 8
– Parity: None
– Stop Bits: 1
– Flow control: Hardware
5. Press Enter until the prompt
> appears. Type in the password to establish the terminal
session and to execute other commands.
Password to be entered:
password
A typical log from a HyperTerminal session is shown in Figure A-4.