Specifications

68 Getting Started with the McDATA Intrepid FICON Director
5.7 Verifying and backing up the configuration
You should have finished the following installation and configuration steps in this chapter:
򐂰 Enter Director Domain ID
򐂰 Connect ISLs to build a fabric
򐂰 Select S/390 operation mode
򐂰 Enable Control Unit Port (CUP)
򐂰 Enable High Integrity Feature
򐂰 Add Directors to membership list
򐂰 Enable fabric binding
򐂰 Enable Switch Binding
򐂰 Configure ports
򐂰 Define port names and block ports
򐂰 Define Zones and zone sets
򐂰 Add ports to zones
򐂰 Activate zone set
The current configuration information should be saved and printed. Some export options are
available to export configuration data into a file on the EFC Manager workstation:
򐂰 Export Configuration Report for each Director
򐂰 Export Logs for each Director
򐂰 Export Fabric Topology for each fabric
򐂰 Export Zone Set for each fabric
򐂰 Export Logs for each fabric
Check logs for all Directors and fabrics for any unresolved error occurred during installation
and configuration tasks. It there are any errors they should be fixed now.
Export Fabric topology for each fabric. Select
Fabrics - Export Fabric Topology... from the
menu bar. In the next displayed window select the subDirectory where the file should be
stored and type a file name. Click
Save to start the export function. The data are stored in
XML format and can be viewed by any editor program as shown in Figure 5-30.
Figure 5-30 Fabric Topology export file view (xml format)
Export zone set for each fabric. Open the Zoning Library window and select File - Export
Zone Set...
from the menu bar. In the next displayed window select the subDirectory where
the file should be stored and type in a file name. Click
Export. The data are stored in XML
format and can be viewed by any editor program, as shown in Figure 5-31.