Specifications

66 Getting Started with the McDATA Intrepid FICON Director
If you want to disable the default zone feature, select Configure - Advanced Zoning -
Configure Default Zone
from the menu bar. On the next panel you can enable or disable the
default zone feature.
It is not necessary to deactivate the current active zoneset. Activation of a new zoneset
replaces the current active zone set. Deactivating the current active zone set causes the
default zone to be activated if the default zone feature is enabled.
To deactivate the current zone set, select from the menu bar
Configure - Advanced Zoning
- Deactivate Zone Set.
On the next panel click the Start button to deactivate the current zone
set and update the fabric.
At installation time there is no current active zone set. To activate a zone set, do the following:
1. In the EFC Manager window click the
Fabrics tab.
2. Click the
Zone Set tab.
3. Select
Configure on the menu bar.
See Figure 5-28 for an example of the above steps.
Figure 5-28 Activate Zone Set
4. On the pull-down, click Activate Zone Set...
5. The next screen shows a list of all defined zone sets. Select a zone set from the list, then
click
Next.
Important: If you deactivate the active zoneset and the default zone feature is enabled,
then all nodes in the fabric will be able to communicate with all other nodes. This could in
turn lead to violations of your security policies.
Select Fabrics
Select Zone Set
Select Configure
Click on Activate Zone Set