Specifications

Chapter 5. Configuring the FICON Director 51
Figure 5-7 List of enabled features
To enable the FICON Management Server feature, do the following:
1. Select
Management Server from the Configure menu. Enable the management server by
clicking the
Enable Management Server option.
2. Click
Director Clock Alert Mode. If this is enabled, the following occurs when users set
the date and time through the Configure Date and Time dialog box.
– If you enable Periodic Date/Time Synchronization, an error message displays, saying
Clock Alert Mode must be cleared to enable automatic date and time synchronization.
– If you manually set the date and time (Periodic Date/Time Synchronization is not
enabled), a confirmation dialog box appears. You must click
OK on that dialog box to
continue manual date and time configuration.
3. Click
Host Control Prohibited to prohibit a host management program from changing
configuration and connectivity parameters on the Director. In this case, the host program
has only read access to these parameters. When a check mark is not displayed, the host
program can change configuration and connectivity parameters.
4. Click the
Programmed offline state control to enable a host management program to
control the Director offline and online state. When a check mark is not displayed, a host
program cannot set the Director online or offline.
5. Click the
Active=Saved option to enable the active=saved function for the IPL address
configuration.
Note: The following options are not required, and should be set to satisfy your
requirements.