Specifications

Chapter 5. Configuring the FICON Director 49
The following steps describe how to activate the SANtegrity feature:
1. Double-click the
Director to activate the SANtegrity feature. Click the Configure tab, then
the
Features option, as shown in Figure 5-5.
Figure 5-5 Feature key installation
2. On the drop-down select New, then enter the feature key in the entry field. Click OK (see
Figure 5-6).
Important: If the you decide to use 2-byte link addresses in your switched point-to-point
configuration, then the Director must have the SANtegrity feature installed. See 3.5,
“Binding and Insistent Domain ID” on page 28 for details.
Note: Both FICON Directors must be at the same firmware level before being merged
into a High Integrity fabric.