Manualshelf

Service manual

ManualsBrandsMcDATA ManualsComputer equipmentIntrepid 6064 Director
71727374757677787980
2
Installation Tasks
2-29
Installation Tasks
• Authentication settings - The Authentication Settings View
provides pages to configure the optional SANtegrity
authentication features, including:
— User settings - Use this page to configure password-protected
administrator and operator access to the EFCM Basic Edition
and command line interfaces.
— Software settings - Use this page to configure challenge
handshake authentication protocol (CHAP) controlled
management interface access (out-of-band and inband) to the
director.
— Device settings - Use this page to configure a CHAP secret
authentication sequence for nodes (devices) attached to the
director through E_Ports or N_ports.
— Port settings - Usethispagetooverridedirector-level
authentication settings and enable or disable device
communication on a per-port basis.
• Access control list - Aspart ofSANtegrity authentication, use the
IP Access Control List View to configure a list of device IP
addresses or a range ofdevice IP addresses that are authorized to
communicate with the director.
• RADIUS - As partof SANtegrity authentication, use theRADIUS
Server View to configure up to three remote authentication dial-in
user service (RADIUS) servers. A RADIUS server stores and
authenticates passwords and CHAP secrets.
• Enterprise Fabric Mode - Use the Enterprise Fabric Mode View to
enable ordisable Enterprise Fabric Mode (EFM).Fabric binding is
activated when EFM is enabled.
• Fabric binding - Use the Fabric Binding View to lockparameters of
a fabric in accordance with the user configuration. Fabric binding
creates a membership list of element (director or switch)
Domain_IDs and worldwide names (WWNs) that can
communicate with the director.
• Switch binding - Use the Switch Binding View to create a
membership list of node (device) WWNs that can attach to the
director. The specified connection policy restricts director access
through E_Ports, F_Ports, or in general (all ports).
• Port binding - Use the Port Binding View to bind an attached
device WWN to a director Fibre Channel port.