Service manual

2
2-24
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
Figure 2-11 CLI View
Enable or Disable Host Control
Perform this procedure to toggle (enable or disable) host control of
the director through the OSMS. The OSMS PFE key must be installed
(Install PFE Keys (Optional) on page 2-26). To enable or disable OSMS
and host control:
1. Select OSMS from the Configure menu at any view. The OSMS
View displays (Figure 2-12).
2. Perform one of the following:
• Click Enable to activate OSMS.
• Click Disable to deactivate OSMS.
3. Check the EnableHost Control checkbox to activate host control of
the director.
4. Click OK to save and activate changes.
Figure 2-12 OSMS View