Service manual

2
2-22
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
(Install PFE Keys (Optional) on page 2-26). Perform this procedure to
configure ports for NPIV connectivity.
1. Select Ports and NPIV from the Configure menu at any view. The
NPIV View displays.
2. Click Enable to activate director NPIV operation.
3. To set a port to a user-specified value, type the desired value (1
through 256)intheLogin column.
4. Click OK to save and activate changes.
Configure SNMP
Perform this procedure to configure names, write authorizations,
addresses, and user datagram protocol (UDP) port numbers for
SNMP trap message recipients. To configure recipient workstations:
1. Select SNMP from the Configure menu at any view. The SNMP
View displays (Figure 2-10).
Figure 2-10 SNMP View
a. Click Enable to activate the installed SNMP agent.
b. Select the Fibre Alliance management information base (FA
MIB) from the FA MIB Version drop-down list. Valid selections
are FA MIB Version 3.0 or FA MIB Version 3.1.