Service manual

2
2-18
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
Principal is the highest priority setting, Default is next, and
Never Principal is the lowest. At least one switch in a fabric
must be set as Principal or Default. If all switches are set to
Never Principal, all ISLs segment.
d. Select from the Interop Mode drop-down list to set the director
operating mode. This setting affects the mode used to manage
thedirectoranddoesnotaffectportoperation.Available
selections are:
• McDATA Fabric 1.0 - Select this option if the director is
fabric-attached only to other McDATA directors or
switches operating in McDATA fabric mode.
• Open Fabric 1.0 - Select this option (default) for managing
heterogeneous fabrics and if the director is fabric-attached
to McDATA directors or switches and other open-fabric
compliant switches.
NOTE: WithOpen Fabric1.0 enabled, the defaultzone setis disabled.
3. Click OK to save and activate changes.
4. Set the director online (Setting the Director Online or Offline on
page 4-36).
Configure Network Information
Verify the LAN installation with the network administrator.
• If one director is installed on a dedicated LAN, network
information(IPaddress, subnet mask,andgatewayaddress)does
not require change.
• If multiple directors are installed or a public LAN segment is
used, network information must be changed to conform to the
LAN addressing plan.
Perform this procedure to change director network information.
1. Select Switch and Network from the Configure menu at any view.
The Network View displays (Figure 2-8).