Service manual

2
2-12
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
— If the director will be managed through the EFCM Basic
Edition interface, go to Task 4: Configure Director at the EFCM
Basic Edition Interface (Optional).
— If the will be managed through a management or
customer-supplied server, go to Task 5: Configure Director
Network Information (Optional) on page 2-30.
Task 4: Configure Director at the EFCM Basic Edition Interface
(Optional)
Perform these procedures to configure the director from the EFCM
Basic Edition interface. A browser-capable PC with Internet or
Ethernet LAN access is required. To open the EFCM Basic Edition
interface:
1. Connect the Ethernet patch cable (supplied with the product) to
the RJ-45 connector (labelled 10/100)atthefrontpanel.
2. Connect theremaining end ofthe Ethernet cable tothe Internet or
LAN segment as directed by the customer. If the hub installed in
Task 2: Unpack, Inspect, and Install the Ethernet Hub (Optional)
provides connectivity, connect the cable to any available hub port.
3. At the PC, launch the browser application (Internet Explorer or
Netscape Navigator).
4. Enter the default Internet Protocol (IP) address of the director
(10.1.1.10) as the uniform resource locator (URL). The Enter
Network Password dialog box displays.
5. Type the case-sensitive default user name (Administrator)and
password (password) and click OK.TheFirst Time Login View
displays.
6. Type customer-specified values in the User Name, New Password,
and Confirm Password fields, then click Activate.TheTopology View
displays with status information about each fabric element,
including the director to be configured.
7. Click Switch Details.TheHardware View displays.
8. Selectively perform the following tasks according to customer
requirements:
• Product - includes identification, date and time, parameters,
fabric parameters, and network addresses.