Service manual

2
2-8
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
Figure 2-1 Patch Cable and MDI Selector Configuration
Rack-Mount Installation
Perform the following steps to install and configure up to three
Ethernet hubs in a Fabricenter cabinet or 19-inch equipment rack. A
pointed instrument (pencil tip or bent paper clip), #2 Phillips
screwdriver, and 1/8-inch Allen wrench are required.
1. Secure one mounting bracket to each side of the first hub
(Figure 2-2). Use the two brackets and four pan-head Phillips
screws (8/32 x 0.5-inch) provided.
Figure 2-2 Mounting Bracket Installation (Ethernet Hub)