Service manual

2
2-6
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
Task 2: Unpack, Inspect, and Install the Ethernet Hub (Optional)
The director is managed through either:
• A 10/100 megabit per second (Mbps) LAN connection to a
management server. Connectivity may require installation of a
24-port Ethernet hub. A combination of up to 48 products can be
configured and managed on one network, therefore multiple,
daisy-chained hubs may be required to provide sufficient port
connections.
• An Internet connection to a browser-capable PC (EFCM Basic
Edition interface). Connection of a LAN segment with multiple
products to the Internet may require installation of a 24-port
Ethernet hub.
Follow the instructions in Unpack and Inspect Ethernet Hub below to
unpack, inspect, and install the Ethernet hub, but:
• If the existing Ethernet LAN segment is adequatefor connectivity
andahubisnotdelivered,thistaskisnotrequired.GotoTa sk 3 :
Unpack, Inspect, and Install the Director on page 2-9.
• If the hub is delivered in a Fabricenter equipment cabinet, go to
Task 5: Configure Director Network Information (Optional) on
page 2-30.
Unpack and Inspect Ethernet Hub
Unpack and inspect the Ethernet hubs.
1. Inspect shipping containers for damage. If a container is
damaged, ensure a freight-carrier representative is present when
the container is opened. Unpack shipping containers and inspect
each item for damage. Ensure packaged items correspond to
items listed on the bill of materials.
2. If items are damaged or missing, contact the solution center:
Phone: [phone] or [phone]
Fax: [phone]
E-mail: [e-mail]