Service manual

5-42

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16” door tool into

the socket hole at the right top of the front door. Turn the tool

counter-clockwise to unlock and open the door. Repeat this

step to open the rear door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet front door as directed by

the customer representative. Repeat this step to open the rear

door.

4. Power off and unplug the director (Power-Off Procedure on

page 4-35).

DANGER

Disconnect the power cords.

5. If necessary, record the director serial number.

6. Follow ESD procedures by attaching a wrist strap to an approved

bench grounding point and your wrist.

ATTENTION! To avoidcausing machine errorsor damagewhileworkingon

the director, follow ESD procedures by connecting a grounding cable to an

approved bench grounding point and wearing an ESD wrist strap.

7. Unseat and disconnect all logic cards (CTP2 and port cards) from

the backplane. Unseat the cards only, do not remove them from

the directorchassis. Inaddition, do notdisconnect the Ethernet or

fiber-optic cables. For each logic card:

a. Insert the torque tool into the locking Allen screw at the

bottom of the card. Turn the screw counter-clockwise until the

spring releases and the tool turns freely.

b. Insert the torque tool into the Allen screw at the top of the

card. To unseat the card and cam it out of the backplane, turn

the screw counterclockwise until the tool turns freely.

c. Disconnect thecard from thebackplane bypulling itout ofthe

card track approximately two inches.

8. Unseat and disconnect (but do not remove) both power supplies

(RRP: Power Supply on page 5-24).

9. Remove the RFI shield (RRP: RFI Shield on page 5-28).