Service manual

5-38

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

ATTENTION! To avoidcausing machine errorsor damagewhileworkingon

the director, follow ESD procedures by connecting a grounding cable to an

approved bench grounding point and wearing an ESD wrist strap.

5. Unseat and disconnect (but do not remove) both power supplies

(RRP: Power Supply on page 5-24).

6. Remove the RFI shield (RRP: RFI Shield on page 5-28).

7. Remove both SBAR assemblies (RRP: SBAR Assembly on

page 5-29).

8. Six panhead Phillips screws (two at the top and four at the

bottom)securethe powermoduleassemblyto thedirectorchassis

(Figure 5-12). Using a standard Phillips screwdriver, loosen and

remove the screws.

Figure 5-12 Power Module Assembly Removal and Replacement

9. Pull the power module assembly (with the SBAR assembly

support shelf) out of the director chassis. Support the assembly

with one hand when performing this step.

10. Place the power module assembly in an anti-static bag to provide

ESD protection.

Replacement To replace the power module assembly:

1. Remove the replacement power module assembly from its

protective anti-static bag.