Service manual

5
5-34
Intrepid® 6064 Director Installation and Service Manual
Removal and Replacement Procedures (RRPs)
Figure 5-11 Fan Module Removal and Replacement
6. Using the rear of the fan module as a handle, pull the module
from the director. Support the fan module with one hand.
ATTENTION! Do not remove a fan module unless the replacement module
is available. Operation of the director with only one fan module for an
extended period may cause one or more thermal sensors to post event codes.
7. Placethefanmoduleinananti-staticbagtoprovideESD
protection.
Replacement To replace the fan module:
1. Remove the replacement fan module from its protective
anti-static bag.
2. Inspect the PWA on the underside of the fan module for bent or
broken connector pins that may have been damaged during
shipping. If any pins are damaged, obtain a new fan module.
3. Position the fan module at the rear of the director chassis
(Figure 5-11). Using the rear of the fan module as a handle, push
themoduletowardthebackplanetoengagetheconnectorpins.
Support the fan module with one hand.
4. Using a standard flat-tip screwdriver, tighten the two captive
screws that secure the fan module to the director chassis.
5. Disconnect the ESD wrist strap from thedirector chassis and your
wrist.