Service manual

5
5-28
Intrepid® 6064 Director Installation and Service Manual
Removal and Replacement Procedures (RRPs)
RRP: RFI Shield
Use the following procedures to remove or replace the rear RFI
shield. A list of tools required is provided.
Tools Required The following tools are required to perform these procedures.
• Door key with 5/16-inch socket (provided with the FC-512
Fabricenter equipment cabinet).
• Standard flat-tip screwdriver.
Removal To remove the RFI shield:
1. Five captive screws (three upper and two lower) secure the RFI
shield to the chassis (Figure 5-9). Using a flat-tip screwdriver,
loosen all five captive screws until they release. Loosen the top
center screw last.
2. Pull the RFI shield away from the director chassis.
.
Figure 5-9 RFI Shield Removal and Replacement
Replacement To replace the RFI shield:
1. Position the RFI shield at the rear of the director chassis
(Figure 5-9).
2. Align the five captive screws with the director chassis anchor
points. Using a flat-tip screwdriver, tighten all five screws.
Tighten the top center screw first.