Service manual

5-24

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

RRP: Power Supply

Use the following procedures toremove or replace apower supply. A

list of tools required is provided.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• ESD grounding cable and wrist strap.

Removal To remove a power supply:

1. If the director is installed in a stand-alone configuration, go to

step 2. If the director is rack-mounted, perform one of the

following:

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16" door tool into

the socket hole at the right top of the front door. Turn the tool

counter-clockwise to unlock and open the door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet front door as directed by

the customer representative.

2. Follow ESD procedures by attaching a wrist strap to the director

chassis and your wrist (Figure 5-1).

ATTENTION! To avoidcausing machine errorsor damagewhileworkingon

the director, follow ESD procedures by connecting a grounding cable to the

director chassis and wearingan ESD wrist strap.

3. For power supply access, rotate the cable management assembly

upward until the right-side captive pin engages, locking the

cable management assembly in the up position.

4. Identify the defective power supply from the extinguished green

PWR OK LED on the supply or failure information at the

management server Hardware View.

5. Push the locking pin to the left to release the cam lever at the top

of the power supply (Figure 5-8,partA).

6. Pull the cam lever out and to the right to cam the power supply

out of the director chassis (Figure 5-8,partB).