Service manual

5
RRP: Filler Blank (UPM)
5-23
Removal and Replacement Procedures (RRPs)
Figure 5-7 Filler Blank Removal and Replacement
Replacement To replace a filler blank:
1. Remove the filler blank from its packaging.
2. Hold the filler blank by its stiffener and insert it in the chassis
card track (Figure 5-7).
3. To secure the filler blank, sequentially insert the torque tool into
each locking Allen screw. Turn each screw clockwise until you
feel the torque tool release and hear a clicking sound. As each
screw turns clockwise, the filler blank locks into place.
4. Verify the filler blank stiffener is flush with the front of the card
cage and even with other director logic cards.
5. Closeandlocktheequipmentcabinetdoor.